O-Grip Safety Grating Accessories For Easy Installation
OGSA-01: Bolt washer seat.
Bolt Washer Seat
Bolt washer seat punched with oblong holes is designed for mounting the O-grip safety grating to I-beam or other anchoring cross members. Field drilling is required.
| Items | Number |
|---|---|
| Bolt washer seat | 1 |
| carriage bolt: 3/8"-16 | 1 |
| Flat washer: 3/8" | 1 |
| Hex nut: 3/8"-16 | 1 |
| Plank carriage bolt height = side channel height + 1". Walkway way carriage bolt: 5/16"-18 × 2". |
|
J-clip
J-clip is used to secure the O-grip safety planks to I-beam or other anchoring cross members without drilling holes. In contrast with bolt washer seat, J-clip installation is quicker and simpler.
| Items | Number |
|---|---|
| P-bolt seat | 1 |
| Carriage bolt: 3/8"-16 | 1 |
| Flat washer: 3/8" | 1 |
| Hex nut: 3/8"-16 | 1 |
| Note: Plank carriage bolt height = side channel height + 1". Walkway carriage bolt: 5/16"-18 × 2". |
|
OGSA-02: J-Clip.
OGSA-03: Mid Support Clip.
Mid Clip Kit
Mid clips are used at middle point of the O-grip plank grating to increase load carrying capabilities. Kit includes mid clip and two sets of screws.
Surface splice plate
When the width of walkway grating is greater than 12", surface splice plates are strongly recommended to connect butt ends of planks. There are multiple surface splice plates for different widths including 18", 24", 30" and 36", and hardware is provided separately.
OGSA-04: Surface Splice Plate.
OGSA-05: Walkway Splice Plate.
Walkway Splice Plate
Walkway splice plate attached to the side channels is designed to help O-grip walkway gratings to reach any length. Available for 24" and 30" walkway.
| Items | Number |
|---|---|
| Walkway splice plates: 4-1/2" × 30" | 2 |
| Hex bolts:1/2" × 1-1/4" | 32 |
| Hex nuts: 1/2"-13 | 32 |
| Flat washers: 1/2" | 32 |
Inquiry for Our Product
Hebei Qiusuo Wire Mesh Products Co., Ltd.
E-mail: sales@qs-wiremesh.com
When you contact us, please provide your detail requirements. That will help us give you a valid quotation.
Product List